First, the performance characteristics:
The machine uses aluminum profiles as the frame structure, the overall easy to dismantle, the appearance of no paint, electronic control for the touch screen man-machine interface operation, built-in production time, counting, preset number of automatic shutdown, Taiwan gear motor, inverter Taiwan "Quartet", low-voltage electrical use of "Germany West", the sensor using Japan "Omron", the control system PLC using Japan "Mitsubishi (Mitsubishi)", touch screen using Taiwan "Wei Lun."
Second, the technical parameters:
1, the power supply voltage: AC380V 50HZ
2, power: 4.5KW
3, the design speed: 120 / min
4, the best speed: 60-100 tablets / minute
5, Dimensions: 3330 × 900 × 1350mm
6, machine weight: 650kg
Third, the process:
Elasticity
Non-woven feed - fold - forming - welding - cut off
Fourth, the operating procedures:
1, the non-woven fabric tray in place to adjust the tension device.
2, by the artificial traction by the folding device to the welding machine.
3, enter the rubber band, and lead to ultrasonic welding machine, so that it does not rebound.
4, open the ultrasonic welding machine switch.
5, slowly open the host, to be normal after the input welding machine and cut off the cutter.
Fifth, note:
1, open the host should be opened before the first ultrasonic welding machine to avoid excessive loss of burning.
2, ultrasonic pressure roller pressure should be moderate, too easy to burn the ultrasonic generator, too small, molded is not strong.
3, elastic input on both sides of the tension should be balanced, otherwise the folding is not good.
Sixth, maintenance and repair:
1, regularly check the cutting edge, and timely repair.
2, molded roller bearings should be regularly filling lubricants and check for damage.
3, on time to check whether the operation of the normal operation, flexible.